Journal of Transportation Infrastructure Engineering

Journal of Transportation Infrastructure Engineering

Evaluation of Shape Factor Variations in Cubic and Pyramidal Ballast Particles under Breakage

Document Type : Research Paper

Authors
1 MSc Student, Civil Engineering Faculty, Sahand University of Technology, Tabriz, Iran
2 PhD, Civil Engineering Faculty, Sahand Earthquake Resaerch Center (SERC), Sahand University of Technology, SUT, Tabriz, Iran.
3 Postdoctoral researcher, Civil Engineering Faculty, Sahand Earthquake Resaerch Center (SERC), Sahand University of Technology, SUT, Tabriz, Iran.
4 Civil Engineering Faculty Sahand University of Technology SUT
Abstract
Particle shape plays a key role in the mechanical performance of coarse-grained materials in civil engineering applications, particularly when particle breakage occurs. This study experimentally investigates the effect of particle breakage on shape factor changes of angular railway ballast particles with pyramidal and cubic geometries in the ballast size range of 2–6 cm. To minimize the inherent variability of natural aggregates, artificial particles were fabricated from reactive powder concrete (RPC), with compressive strength comparable to that of natural ballast. Pyramidal and cubic particles were then subjected to compressive loading until failure, and their geometric changes were quantified using the relative shape factor. The shape factor distributions were classified into four categories: low, medium, high, and very high. The results show that the initial particle geometry strongly affects both breakage behavior and the post-loading distribution of shape factors. For pyramidal particles, about 84% fell within the medium range, and the remaining particles were classified as low. In contrast, cubic particles exhibited a wider distribution: 25% were in the high and very high ranges, 69% in the medium range, and only 6.5% in the low range. These findings indicate that the initial particle geometry is a governing factor in the extent to which the shape factor is retained or reduced after breakage. PSD analysis showed a higher Hardin breakage factor for pyramidal particles (20.77%) than for cubic particles (12.91%), despite cubic particles having a greater reduction in relative shape factor, suggesting distinct mechanisms govern breakage extent and shape change. Furthermore, pyramidal particles showed less dispersion among the defined shape factor ranges than cubic particles, indicating greater geometric stability of pyramidal forms under compressive loading.
Keywords
Subjects

  • Receive Date 12 July 2026
  • Revise Date 16 October 2026
  • Accept Date 16 October 2026
  • Publish Date 23 October 2026