Laboratory study of shearing resistance of soil reinforced with synthetic fibers

Document Type : Research Paper

Authors

1 Assistant Professor, Department of Civil Engineering, Shahrekord University

2 B.Sc graduated, Department of Civil Engineering, Shahrekord University, Shahrekord, Iran.

Abstract

Soil stabilization is an effective mechanical method for soil rehabilitation against applied loads. In recent years, synthetic fibers have been introduced as a novel technique for soil stabilization. Therefore, it is essential to assess the behavior of fiber-reinforced soils. In this study, the behavior of synthetic fiber-stabilized soil was investigated using laboratory tests. Direct shear experiments were performed on the specimens reinforced with glass and polypropylene fibers, 12 mm in length. The tested specimens were reinforced with random distribution of 0.05, 0.1, 0.2 and 0.5% of synthetic fibers. The direct shear experiments were performed under different vertical stresses. The tests results indicate that the addition of synthetic fibers improves the maximum shear strength of the tested soil samples. Reinforced samples with 0.1% fibers have the highest shear strength of tested soil. Also, the results indicate that under identical conditions, specimens reinforced with polypropylene fibers have higher shear strength than glass fiber-reinforced specimens.

Keywords


ASTM C136. 2006. "Standard test method for analysis of fine and coarse aggregates”. ASTM International, West Conshohocken.
ASTM D3080. 2004. “Standard test method for direct shear test of soils under consolidated drained conditions”. ASTM International, West Conshohocken.
ASTM D698. 2007. “Standard test methods for laboratory compaction characteristics of soil using standard effort”. ASTM International, West Conshohocken.
Ates, A. 2016. “Mechanical properties of sandy soils reinforced with cement and randomly distributed glass fibers (GRC)”. Composites- Part B: Eng., 96: 295-304.
Attom, M. F. and Al-Tamimi, A. K. 2010. “Effects of polypropylene fibers on the shear strength of sandy soil”. Int. J. Geosci., 1(1): 44-50.
Benessalah, I., Arab, A., Villard, P., Sadek, M. and Kadri, A. 2016. “Laboratory study on shear strength behaviour of reinforced sandy soil: Effect of glass-fibre content and other parameters”. Arab. J. Sci. Eng., 41(4): 1343-1353.
Consoli, N. C., Prietto, P. D. and Ulbrich, L. A. 1998. “Influence of fiber and cement addition on behavior of sandy soil”. J. Geotech. Geoenviron. Eng., 124(12): 1211-1214.
Gray, D. H. and Ohashi, H. 1983. “Mechanics of fiber reinforcement in sand”. J. Geotech. Eng., 109(3): 335-353.
Jafarian, Y., Haddad, A. and Javdanian, H. 2015. “Comparing the shear stiffness of calcareous and silicate sands under dynamic and cyclic straining”. 7th International Conference of Seismology and Earthquake Engineering, Tehran, Iran.
Javdanian, H. 2017. “The effect of geopolymerization on the unconfined compressive strength of stabilized fine-grained soils”. Int. J. Eng. Trans. B: Appl., 30(11): 1673-1680.
Javdanian, H., Haddad, A. and Mehrzad, B. 2012a. “Experimental and numerical investigation of the bearing capacity of adjacent footings on reinforced soil”. Electron. J. Geotech. Eng. 17: 2597-2617. 
Javdanian, H., Haddad, A. and Mehrzad, B. 2012b. “Interference effect on bearing capacity of multiple shallow foundations supported by geosynthetic-reinforced sand”. 5th Asian Regional Conference on Geosynthetics, 13 December, Bangkok, Thailand.
Javdanian, H. and Lee, S. 2019. “Evaluating unconfined compressive strength of cohesive soils stabilized with geopolymer: A computational intelligence approach”. Eng. Comput., 35(1): 191-199.
Kaniraj, S. R. and Gayathri, V. 2003. “Geotechnical behavior of fly ash mixed with randomly oriented fiber inclusions”. Geotext. Geomembranes, 21(3): 123-149.
Kumar, R., Kanaujia, V. K. and Chandra, D. 1999. “Engineering behavior of fiber-reinforced pond ash and silty sand”. Geosynth. Int., 6(6): 509-518.
Li, Y., Ling, X., Su, L., An, L., Li, P. and Zhao, Y. 2018. “Tensile strength of fiber reinforced soil under freeze-thaw condition”. Cold Regions Sci. Technol., 146: 53-59.
Marandi, S. M. and Javdanian, H. 2012. “Laboratory studies on bearing capacity of strip interfering shallow foundations supported by geogrid-reinforced sand”. Adv. Mater. Res., 472: 1856-1869.
Nataraj, M. S. and McManis, K.L. 1997. “Strength and deformation properties of soils reinforced with fibrillated fibers”. Geosynth. Int., 4(1): 65-79.
Noorzad, R. and Zarinkolaei, S. T. G. 2015. “Comparison of mechanical properties of fiber-reinforced sand under triaxial compression and direct shear”. Open Geosci., 7(1): 547-558.
Shao, W., Cetin, B., Li, Y., Li, J. and Li, L. 2014. “Experimental investigation of mechanical properties of sands reinforced with discrete randomly distributed fiber”. Geotech. Geolog. Eng., 32(4): 901-910.
Yetimoglu, T. and, Salbas, O. 2003. “A study on shear strength of sands reinforced with randomly distributed discrete fibers”. Geotext. Geomembranes, 21(2): 103-110.
Wang, Y., Guo, P., Shan, S., Yuan, H. and Yuan, B. 2016. “Study on strength influence mechanism of fiber-reinforced expansive soil using jute”. Geotech. Geolog. Eng., 34(4): 1079-1088.